I had a 1989 Ford Probe without a handle that stuck out like a typical car. It was recessed instead.

Better for fuel efficiency, which was also the intention of these stupid flush mount ones Tesla has been fawning over. But these were still manual door handles designed 40ish years ago…

And that’s the fault of whoever uses those hubs. You can use practically any zigbee hub you wish. Zigbee is zigbee.

You didn’t look very hard.

Cheap zigbee stuff exists everywhere. And zigbee is an open standard, so if it works, it will work until the equipment breaks.

The Linux kernel isn’t really much different between any distribution of Linux.

If it works on one, it works on the rest, in like 99% of cases.

The only real exception to that is custom distributions built specifically for a particular device or subset of devices.

In other words, for embedded devices, like phones, routers, TVs and such.

And those aren’t going to be running Ubuntu.

Naive? No. What’s naive is thinking that if you give power to anyone over your own data , even your government, that it will.protect it.

You think the EU cares about your privacy? I know my own government is doing it’s level best to destroy mine, but at least I’m aware of it.

You, however, have the naivete of Pollyanna and think your vaunted EU is better.

That sounds like privacy, not evil.

Because history, as well as current events, tell us that governments will absolutely make privacy illegal, so if you can do an end run of them by not being beholden to ANY government, then that is absolutely a good thing.

In my own experience, certain things should always be on their own dedicated machines.

My primary router/firewall is on bare metal for this very reason.

I do not want to worry about my home network being completely unusable by the rest of my family because I decided to tweak something on the server.

I could quite easily run OpnSense in a VM, and I do that, too. I run proxmox, and have OpnSense installed and configured to at least provide connectivity for most devices. (Long story short: I have several subnets in my home network, but my VM OpnSense setup does not, as I only had one extra interface on that equipment, so only devices on the primary network would work)

And tbh, that only exists because I did have a router die, and installed OpnSense into my proxmox server temporarily while awaiting new-to-me equipment.

I didn’t see a point in removing it. So it’s there, just not automatically started.